Developer tag

Pozyx Creator/Enterprise/Individual units 320

Track things in real-time with high accuracy. Thanks to state-of-the-art UWB technology, you get precise positioning that's accurate up to 10 cm. Combined with smart and extensible hardware and software interfaces, you're ready to unlock a new world of positioning information.

In stock. Shipped in 1 week.

  • Power-bank
  • Data-cable
  • Configuration

158.15 175.00 175.0 USD

€ 135.00

This combination does not exist.

Developer tag

Overview

The tag provides accurate positioning and motion information. The tag is meant to work in combination with anchors, either from the Creator series or the Enterprise series. The tag does not need an Arduino to work.

Headered vs Headerless configuration: The headered tag is is a shield compatible with Arduino. The headerless tag is identical to the shield compatible with Arduino with the exception that the stacking header pins are not present. This makes the tag smaller.

  • Works with both the Creator and the Enterprise series
  • Compatible with Arduino Uno R3, Nano and Mega through I2C
  • Compatible with Raspberry Pi through micro USB
  • On-board ultra-wideband transceiver
  • On-board 9-axis inertial measurement unit
  • On-board pressure sensor
  • Operating voltage 3.3 V

Description

The Pozyx developer tag provides accurate positioning and motion information. For this, it utilizes a set of sensors and an ultra-wideband (UWB) transceiver. The principal component is the DW1000 UWB-chip from Decawave that is used for wireless ranging and messaging. Furthermore, the board is equipped with a 9-axis inertial measurement unit for orientation information. 

On board interfaces


  • I2C. Arduino communicates with the Pozyx tag by means of I2C (SCL and SDA pin) and two optional interrupt pins (pins 2 or 3). Because the I2C bus can be shared with other peripherals, the tag will not interfere with other Arduino shields. The ICSP header from the Arduino is not passed through, hence other boards requiring this interface must be stacked lower than the Pozyx tag.
  • Micro USB. The micro USB can be used for three purposes: Firstly, for updating the Pozyx firmware in case new features are provided by us. Secondly, it can be used to connect (and power) the tag to a computer. This way, the tag can be controlled through the computer without requiring an Arduino. Finally, it can be used to connect a Raspberry Pi in order to retrieve sensor's data.

Board

Arduino compatibility Uno R3, Mega and Nano
Microcontroller STM32F4
Micro USB For firmware updates and Raspberry Pi connection
LEDs 4 for general purpose + 2 for UWB connectivity
Optional GPIO pins 4
Onboard 3.3 V regulator For automatic power selection from battery, Arduino or USB
Size 6 cm x 5.3 cm
Weight 12 g

Ultra-wideband

Transceiver Decawave DW1000
Chip antenna Onboard
Accuracy Up to 10 cm
Frequency range 3.5 - 6.5 GHz
Communication Up to 6.8 Mbps
Range Up to 100 m

Motion sensors

Chip BNO-055
Accelerometer 3-axis
Gyroscope 3-axis
Compass 3-axis
Pressure sensor MPL3115A2

More products for you

Enterprise kit

The go-to solution for your enterprise grade indoor positioning needs. Scalable to unlimited area sizes.

More info
Enterprise kit Lite

The go-to solution for an enterprise RTLS validation.

More info